Wilcom NID POTS Splitter
PS-11-I2
- The PS-11 POTS Splitter is compatible with all ADSLcoding schemes
- Meets ANSI T1.413 -1998 & ITU-T G.992.1/.2
- Designed to TR-127
- Passive Low Pass Filter
- The PS-11 is similar in size to a standard station protector allowing direct installation into a wide variety of manufactured Network Interface Devices.
- Convenient Mounting
- Full bandwidth allocation as compared to a "micro-filter
1 800 204 0555
Email Us
Visiting Us
The Wilcom PS-11 is a master POTS splitter featuring a screw-type terminal block
for weather-proof connections and simple field installation.
The PS-11 passive low-pass filter allows POTS service in concert with ADSL
technology by blocking high frequency (20kHz-2.2MHz) energy from interfering with
voice equipment. The PS-11 is backwards compatible with all xDSL systems.
This splitter sets the standard for ADSL and ADSL2+ performance allowing the
maximum bitrates possible to the customer.
The Wilcom PS-11 POTS Splitter is unique because of its convenient mounting
location inside the Network Interface Device (NID). The PS-11 is similar in size to a
standard station protector and mounts on the Telco side inside the NID. The
terminal block connectors allow for easy installation so the installer can simply
connect the existing premise wiring to the PHONE terminals on the splitter, and
have POTS service up and running within minutes without expensive, and timeconsuming
rewiring. A “home-run” connection with data-grade cable is
recommended direct to the xDSL modem from the ATU-R/MODEM connection on
the splitter.
- Maximum xDSL Bandwidth :2.2 MHz - ADSL2+
- Maximum Bitrate :24 Mbps
- Corner Frequency :7 kHz
- Insertion Loss (1kHz) :< 0.25 dB
- 30kHz Attenuation: > 65 dB
- :Attenuation Distortion (0.2kHz-3.4kHz) < 0.25 dB
- Delay Distortion: < 50 μS
- Return Loss (600+2.16μF, typical) :ERL +27 dB SRL-LO +18 dB SRL-HI +20 dB
- DC Resistance: < 20 Ohms
- Longitudinal Balance :> 70 dB
- Maximum Loop Current :100 mA
- Acceptable Wire Gauge :19-26 AWG
- Connectors :terminal block, 5mm screws
- Dimensions (HWD): 1.4 x 2.3 x 0.75” (36 x 57 x 19mm)
- Temperature (operating & storage): -40°C to +85°C