Wilcom NID-mount VDSL2 POTS Splitter

PS-32

  • The PS-32 Master POTS Splitter is compatible with all ADSL and VDSL2 coding schemes
  • Meets ANSI T1.413 and G.992.1 Specifications
  • The PS-32 has convenient screw type terminals for solid, damp-proof connections.
  • The PS-32 addresses specific concerns with video pixelization during ringing or ring-trip conditions.
  • The PS-32 POTS Splitter mounts like a standard station protector iin the Telco side of the Network Interface Device.
  • Supports connections to 30 MHz for the full 4096 subcarriers and data speeds of 200 Mbps.

The Wilcom PS-32 VDSL2 POTS Splitter is a passive low-pass filter designed to provide POTS service in concert with DSL technology. The device blocks high frequency (20kHz - >30MHz) energy from interfering with POTS equipment. The PS-32 employs a low-pass filter for standard voice-grade lines.
The Wilcom PS-32 POTS Splitter is unique because of its convenient mounting location inside the Network Interface Device (NID). The PS-32 is ideally suited for video over DSL applications such as IPTV (Internet Protocol Television) over ADSL2+ or VDSL2. The PS-32 includes robust ring-trip protection for non-zero cross ringers to eliminate video artifacts due to pixelization. The PS-32 is similar in size to a standard station protector and mounts on the Telco side inside the Network Interface Device. The terminal strip allows for easy installation so the installer can simply connect the existing premise wiring to the PHONE terminals on the splitter, and have POTS service up and running within minutes without expensive, and time-consuming rewiring. ATU-R terminals connect directly to the DSL equipment with existing cable. (Data-grade cabling is recommended for new installations.)

  • Maximum xDSL Bandwidth :30 MHz - VDSL2 profile 30a
  • Maximum Bitrate :200 Mbps
  • Corner Frequency :7 kHz
  • Insertion Loss (1kHz) :< 0.25 dB
  • 30kHz Attenuation :> 65 dB
  • Attenuation Distortion (0.2kHz-3.4kHz): < 0.25 dB
  • Delay Distortion :< 50 μS
  • Return Loss (600+2.16μF, typical): ERL +27 dB SRL-LO +18 dB SRL-HI +20 dB
  • DC Resistance :< 20 Ohms
  • Longitudinal Balance :> 70 dB
  • Maximum Loop Current :300 mA
  • Acceptable Wire Gauge :19-26 AWG
  • Connectors: terminal block, 5mm screws
  • Dimensions (HWD) :1.7 x 2.3 x 0.75” (43 x 57 x 19mm)
  • Temperature (operating & storage) :-40°C to +85°C
Back to Top